Chrysler Repair: 1998 Sebring LXi 2.5- Replacing lights, hood latch, lamp bulb

Question
Map lights- Do I need to remove the rearview mirror and disassemble to replace them? If so is it held in by torque screws?

Floor lights- Near the feet of the driver, and passenger.

Rear passenger brake light- How do I get the damn thing out to change the bulb? Or is it accesible through the trunk?

Answer
FRONT MAP LAMP BULB
REMOVAL
Using a small, flat bladed tool inserted into slot in lamp lens, remove map lamp lens.
Pull bulb from map lamp.
INSTALLATION
Push bulb into map lamp.
Install map lamp lens.

FLOOR CONSOLE COURTESY LAMP BULB
REMOVAL
Using a small, flat bladed tool inserted into top edge of courtesy lamp, separate courtesy lamp from floor console Floor Console Courtesy Lamp
Rotate bulb socket counterclockwise one quarter turn.
Pull bulb socket from courtesy lamp.
Pull bulb from bulb socket Floor Console Courtesy Lamp Bulb
INSTALLATION
Push bulb into bulb socket.
Push bulb socket into courtesy lamp.
Rotate bulb socket clockwise one quarter turn.
Position lower edge of courtesy lamp to floor console.
Snap courtesy lamp into floor console.

PARK AND TURN SIGNAL LAMP BULB
REMOVAL
Release hood latch and open hood.
Remove screws holding headlamp module to radiator closure panel.
Separate headlamp module from radiator closure panel.
Rotate socket counterclockwise one quarter turn.
Pull socket from back of lamp Park and Turn Signal Lamp Bulb
Pull bulb from socket.
INSTALLATION
Push bulb into socket.
Position socket into back of lamp Park and Turn Signal Lamp Bulb
Rotate socket clockwise one quarter turn.
Position headlamp module to radiator closure panel.
Install screws holding headlamp module to radiator closure