Chrysler Repair: shift solenoid on a 2000 town& country, transmission oil cooler, transmission control module

Question
How do I change a shift solenoid on a 2000 town country 3.8 liter engine. and where is it located

Answer
SOLENOID/PRESSURE SWITCH ASSEMBLY
REMOVAL
Disconnect battery negative cable.
Remove air cleaner assembly.
Remove the Transmission Control module (TCM) Transmission Control Module (TCM)
Disconnect and remove the input speed sensor Input Speed Sensor
Disconnect the transmission oil cooler lines. Cap off hoses and fittings to prevent foreign matter intrusion.
Disconnect the solenoid/pressure switch assembly connector.
Remove the three solenoid/pressure switch assembly-to-transaxle case bolts Attaching Bolts
Remove solenoid/pressure switch assembly and gasket Solenoid/Pressure Switch Assembly and Gasket
CAUTION: Be sure to keep foreign material from entering ports in transaxle case. Erratic transaxle operation and/or failure can result

INSTALLATION
Install solenoid/pressure switch assembly to case using a new gasket Solenoid/Pressure Switch Assembly and Gasket
Install bolts and torque to 13 N·m (110 in. lbs.) Attaching Bolts
Install 8-way connector and torque screw to 4 N·m (35 in. lbs.)
Uncap and install transmission oil cooler lines.
Install input speed sensor Input Speed Sensor and torque to 27 N·m (20 ft. lbs.)
Install Transmission Control Module (TCM) Transmission Control Module (TCM)
Install air cleaner assembly.
Connect battery negative cable.
Perform Transaxle Quick Learn Procedure. Refer to Service Procedures.