QuestionQUESTION: Where is the thermostat and do i have to have a special tool for the clamps how do i replace it?
ANSWER: Hi Kyle,
You didn't mention which engine you have (2.7 or 3.2L). Each is different, but both have the thermostat located on the lower left side of the engine near the front. Follow the lower radiator or heater hoses to find it. Let me know which engine you have and I'll type in a step-by-step procedure for your use. Send a follow-up with that information.
Roland
---------- FOLLOW-UP ----------
QUESTION: the 2.7 liter sorry
AnswerHi Kyle,
Disconnect the battery negative cable
Drain the cooling system
Raise vehicle
Remove generator attaching bolts, set generator aside for ease of access to thermostat
Remove lower radiator and heater hoses from thermostat housing
Remove housing bolts
Remove housing and thermostat
Installation:
Clean gasket sealing surface
Install thermostat and gasket into thermostat housing
Intall housing and thermostat to cylinder block. Thighten bolts to 105 inch-pounds
Connect heater and lower radiator hoses
Install generator and attaching bolts
Lower vehicle
Install accessory drive belt
Refill cooling system
Reconnect battery cable
To remove/install belt:
Loosen lock nut on tensioner pulley shaft
Loosen belt adjusting bolt
Remove belt
That is the procedure. I don't believe that special clamps are involved.
