QuestionI have a 97 lhs,and just bought a keyless entry off of e-bay and I need to program it...I really want to do this myself but I need some info on how it is done.
AnswerHi Tim,
The plug you have to access in behind the middle upper vent bezel of the instrument panel (above the radio). Remove the bezel. Behind the bezel you should find a black plug connector, attached to the bezel or to a traction control switch, with 6 contacts; if you hold it so the pins are three on each side with the "ears" positioned at the bottom middle and bottom right corner, the keyless program contact is the upper left corner. The wire attached to that program contact is dark green in color.
Turn the ignition switch ON. Ground the dark green wire to a shiney metal body surface using a jumper. The door locks will lock and unlock, which means the receiver is ready to receive the code from the new transmitter.
Press any button of the transmitter to set the code. The locks will cycle to confirm programming. If you have another transmitter, do the same for it.
Disconnect the ground from the dark green wire.
Reposition the plug in the manner that you found it.
Replace the middle bezel to the panel.
That should do it. This instruction is from the '94 Chrysler LHS manual.
Roland
