Chrysler Repair: 3.3/3.5L engine stalls,runs,stalls,etc...fault code 11, crankshaft position sensor, wire colors

Question
stalling out just like u cut the key off...happened while going down the road the other night...waited about 45 mins and it started back up. then it would go about 10 miles and do the same thing...waited 45 mins. started back up ...continued on till i was home 5 hrs. later only 40 miles from home
1994 Chrysler LHS
I read the fault code it's only 11

i'm from Mexico and this car is rare here  

Answer
Hi Luis,
That symptom and fault code are very common and easy to repair. It is the crankshaft position sensor that is failing when it operates, then self-repairs when it cools down. So you need to get a replacement and install it. It is located on the passenger side of the engine at the joint where the engine is joined to the transmission (the round differential cover is just below it, specifically the ~2 o'clock bolt on that cover is exactly below the sensor). The wire colors are black/light blue, light blue/dark blue, and orange. Just remove the connector (lift tab), remove screw, put in new sensor, replace screw, replace connector, and you problem will be solved.
Roland
P.S. Don't forget to vote!