Chrysler Repair: Drivers side tire shudder, rod bushings, wheel alignment

Question
Hello Pete:

I have a question about my 1995 intrepid.  About a year changed the inner tigh rod bushings that are located on the rack.  

To make a long story short I had to pull the whole inner and outter tigh rod off the car to change the bushing because some kid gave me the wrong bushing set.  I could not get the bushing into the hole.  I finally gave up and took the whole rod to the parts store and said if you can get this in here you are a better man than me.  

He then realized he gave me the wrong part.  I took the right part home and reconnected it to the car with no problems installing it.  

Here is the problem.  Even since I took the whole rod off the car I have experience an annoying vibration on that same drivers side tire. If I turn the steering wheel to the right a bit going down the road the vibration stops until I straighten out the wheel.  

When the steering wheel is straight the car goes down the road straight but I have that annoying vibration.

Do you think I need a wheel alignment and if I do should I get a two or four wheel?  Or do you have other suggestions to the problem of the annoying vibration?

Thank you for all your help!

Dan Trisevic

Answer
hello dan
a front end allinet would do the trick . they gave you the wright tie rod end i hope i would have the front end allined and if it is the wroang one the tect would know go for it if you need more help just let me know please rate my serivice pete