Classic/Antique Car Repair: vete gas pump, box pop, gunk

Question
hea man do you know how i can get like my fuel pump out as there is a lot of stuff in da way man
i got a 63 vette with a 327 in it all worked on good it got a lot of power.

Answer
well man first if i was yiu i would get that std pump out and the shaft also as you might need more gas than that pump is giving to you. first thimg you might have to un do the motor mount on that side and lift the engine up a inch or two. than you will be able to get thr old pump out and off of the engine.than remove the second cover plate and take out the  rod that pushes on the gas pump to make it work on/off etc. get it out of there, toss it away. now get a chrome block off plate put a lot of gasket gunk on it and put it back in place and cover the pump hole all up / seal it shut not to be used again..now get a good elect fuel pump and put it in the rear under the car someplace to the frame and to make it even better place a second one up front also so you shall now have two (2) one pushing and one pulling, so you will be all set in fuel p.s.i. if you have any type of p.s.i. conditions get a pres. regulator gor the fule line its no big deal it will only adj your fuel to a lower volume thats all only if needed. now you shall see a big difference in gas and ih h.p. and power
as your head will snap back when you do a hi rev shift, as mine at second gear would open up the glove box, pop out the cig lighter and also make the 8 track tape come popin out. this is for real man no joke it did.but you must remember that all of this power can and will kill you as i had a few bad ones so please i will tell you how to build the power but i do not want to be the one that gave you the know how to wrap yourself around a  pole ok so be save.please
as this is a fun sport but its also very dangerous ok. bigw45