QuestionWhy would my light out indicator go off repeatedly if there are NO lights out? I do not have a manual so I don't know what fuse is what to check them. I tried to find a manual online but I do not have the funds to buy one. I really need your help, this is driving me nuts. Thanks so much. Dawn
Answerwrong bulbs will do this there is also a tsb on this
SUBJECT:
Lamp Out Indicator With Aftermarket Pick Up Box Installation
MODELS:
2003 DR Ram Truck
DISCUSSION:
In situations where an aftermarket utility box is installed after the removal of the original
equipment pick up box, the lamp out indicator may illuminate. This is due to the
use of aftermarket rear stop and turn signal lamps which use a dual filament bulb
instead of separate circuits for the stop and turn indictor. The Front Control Module
(FCM), monitors the current flowing through the stop and turn signal circuits to operate
the lamp out feature. Most aftermarket rear stop and turn signal assemblies use
dual filament bulbs with a common stop and turn circuit. The current flow through
these units will be different than the original equipment lamps.
A new feature has been added to the FCM to allow the use of dual filament rear stop and turn
signals. This feature is called, “Combined Rear Stop and Turn lamps” . It can be programmed
into the FCM using the DRB® III on vehicles built after Aug. 6, 2003 (MDH - 0806XX). To
program the feature, connect the DRB® III and make the following menu selections:
Item No. Description
1 DRB Stand Alone
3 Body
3 FCM/IPM
9 Miscellaneous
4 Comb R Stop & Turn
Vehicles built prior to Aug. 6, 2003 with earlier version FCM’s are not equipped with this
capability. The later version FCM, (p/n 56049681AB) can be installed in these vehicles
to provide the feature. Vehicles purchased as “Cab Chassis” or “Box Off" are shipped
with the feature activated from the factory and do not require programming.
POLICY:
Information Only
