Dodge Repair: passenger side turn signal light, cornwall ontario canada, light buld

Question
HI KEVIN
WOULD YOU BE SO KIND AND ADVISE ME ON HOW TO INSTALL
PASSENGER SIDE TURN SIGNAL LIGHT
I AM 71YRS OLD MY OTHER CARS WERE ALWAYS SO EASY TO CHANGE
A LIGHT BULD
BUT I AM AT A LOST WITH MY CHRYSLER INTREPID 1996 3.3L I OPEN THE HOOD JUST CAN'T FIGURE OUT HOW TO CHANGE THE SIGNAL
LIGHT BULB THERE IS NO ROOM FROM THE INSIDE TO EVEN PLACE
YOUR HAND , PERHAPS ONE AS TO CHANGE IT FROM THE FRONT
I NEVER DID A LIGHT BULB ON THIS, EITHER AS MY NEIGHBOUR
PLEASE ADVISE
THANKING YOU IN ADVANCE
ROMEO HEBERT CORNWALL ONTARIO CANADA

Answer
PARK AND TURN SIGNAL LAMP
REMOVAL
Release hood latch and open hood.
Remove radiator closure panel sight shield as necessary to gain access fasteners.
Remove screw holding park and turn signal lamp to headlamp module mount adapter.
Separate park and turn signal lamp from mount adapter Park and Turn Signal Lamp
Remove socket from park and turn signal lamp.
Separate park and turn signal lamp from vehicle.
INSTALLATION
Place park and turn signal lamp in position on vehicle.
Install socket into park and turn signal lamp.
Place park and turn signal lamp in position on mount adapter.
Install screw to hold park and turn signal lamp to headlamp module mount adapter.
Install radiator closure panel sight shield.
Verify park and turn signal lamp operation.