Dodge Repair: Heated seat 02 Durango, seat failure, indicator lamps


Question
QUESTION: I could not find the rest of the answer to the heated seat question. Also my rear passenger blower is not blowing hot air when the heat is on. What could be the problem with the seat and the rear heater? Thanks

ANSWER: I will need a frame of reference to what question u asked and what I posted.

---------- FOLLOW-UP ----------

QUESTION: My passenger heated seat does not heat, and the light will blink. Also my rear heater blows only cold air. If I was in ATL I'd have you fix it but I'm in Indiana.

Answer
DIAGNOSIS AND TESTING - HEATED SEAT SYSTEM
SELF-DIAGNOSIS
The heated seat system is capable of performing some self-diagnostics. The following table depicts the various failure modes which will be reported to the vehicle operator or technician by flashing the individual heated seat switch Light Emitting Diode (LED) indicator lamps. See the Heated Seat System Self-Diagnosis table for the diagnostic routines. The driver side heated seat switch indicator lamps will flash if a failure occurs in the driver side heated seat, and the passenger side heated seat switch indicator lamps will flash for a passenger side heated seat failure. If a monitored heated seat system failure occurs, the switch indicator lamps will flash at a pulse rate of about one-half second on, followed by about one-half second off for a duration of about one minute after the switch for the faulty heated seat is depressed in either the Low or High direction. This process will repeat every time the faulty heated seat switch is actuated until the problem has been corrected.

Heated Seat System Self-Diagnosis  
Monitored Failure  Switch High Indicator Lamp  Switch Low Indicator Lamp  
Heated Seat Element Shorted  Flashing  Flashing  
Heated Seat Element Open  Flashing  Off  
Heated Seat Sensor Value Out of Range  Off  Flashing  


TESTING
Refer to Wiring for the location of complete heated seat system wiring diagrams.

WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY



chk for low coolant in the radiator for the rear heat inop   also possible blend door or motor broken in the back  can u hear it change when u move it ot to cold?