Questionkevin I have my parts. but needed to know steps of parts I
have to remove to change the valve cover gaskets & # 6 has
a dead miss so am changing plugs & wires dis.cap &
roter this is my first dodge van to have to work on
so need a in site to make it go smoth ??
thanks for aney help you can give me.
AnswerCYLINDER HEAD COVER
REMOVAL
Disconnect negative cable from battery.
Remove air inlet resonator when removing left head cover.
When Removing left cylinder head cover, remove dipstick tube.
When removing right cylinder head cover remove wiper unit. Refer to Wiper Unit Removal in
When removing right cylinder head cover, remove accessory drive belt. Refer to Accessory Drive Belt Removal in Group 7.
When removing right cylinder head cover, disconnect generator wiring and remove generator.
Relocate spark plug wires.
Remove vacuum connections.
Remove rocker cover screws and remove cover Rocker Cover
INSTALLATION
Clean cylinder head and cover mating surfaces. Install new gasket.
See Rocker Cover and apply sealant such as Mopar Silicone Rubber Adhesive Sealant to cover ends.
Install cover and tighten cover bolt washer and gasket assembly to 10 N·m (88 in. lbs.)
Reverse removal procedures for installation.
