QuestionI have replaced starters before on other cars. I need to replace the starter on my 1999 Intrepid 2.7V6. I have Chilton instructions but I can't tell if that will suffice. Should I attempt it or is it too difficult requiring a tow in.
AnswerSTARTER
2.7L ENGINE
REMOVAL
Disconnect battery negative remote cable from remote ground post Negative Battery Cable Remote Terminal
Raise vehicle.
Remove two wiring harness connectors. One for battery feed, and one posi-lock connector.
Remove two bolts and one nut to starter heat shield.
Remove three starter attaching bolts from engine/transaxle.
Remove starter assembly from transmission housing.
Rotate starter solenoid toward engine block and slide rear of starter motor out between catalyst and engine mount.
Remove the starter from vehicle.
INSTALLATION
For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.
