Dodge Repair: replace wiper motor, lbs torque, dodge intrepid

Question
how do i replace wiper motor on 97 dodge intrepid

Answer
WIPER MOTOR
REMOVAL
Remove wiper arms and blades, disconnect hoses from in-line connectors Wiper Motor and Linkage Module Be sure that the in-line connector is saved.
Remove the rear hood seal with the cowl top plastic screen and disconnect the washer hose at in-line connector. Save in-line connector.
Disconnect motor connector at back side of housing.
Remove four wiper housing module mounting screws then remove housing.
Remove nut and disconnect wiper drive link from motor crank.
Remove three motor mounting screws.
Lift motor and mounting plate out of housing.
Disconnect motor harness grommet from housing.
INSTALLATION
For installation, reverse the above procedures. Tighten the motor crank nut to 11 to 14 N·m (89 to 124 in. lbs.) torque. Tighten the motor mounting screws to 11 to 12 N·m (89 to 106 in. lbs.) torque.