Ford Repair: door skin removal, self tapping screws, self tapping screw

Question
Hello Erik
i have a 1989 Ford TBird. The drivers side power window has come off it's track and I need to take off the door skin to access the mechanism. I have previously only worked on GM products and can't see how the inner door skin comes off this vehicle. Any help would be greatly appreciated.

Al

Answer
Hello and thanks for the question...I'll try to help.
Remove window regulator switch housing.
Remove door inside handle cup (snaps out).
Remove self-tapping screw retaining door trim panel upper front extension assembly. Remove extension assembly.
Remove two self-tapping screws retaining door trim panel to door inner panel.
Lift door trim panel upward and snap out trim panel.
Disconnect wire harness for courtesy lamp.
Installation
Connect courtesy lamp connector.
Install door trim panel (lower portion first). Push in until it snaps in place.
Install two self-tapping screws retaining trim panel to inner panel.
Position extension assembly. Install self-tapping screw.
Snap in door inside handle cup.
Install window regulator switch housing.

Hope this helps,
Erik