Isuzu Repair: factory alarm system, isuzu amigo, dash area

Question
I have a 99 Isuzu amigo 6cyc. 2wd with factory alarm. The alarm goes off randomly for no reason. How can this be fixed or disconnected?

thanks
my neighbors will love you!

Answer
I think I may have a solution for you Pam:) Try this(found it somewhere on this very website) and if it does not work let me know and we will go from here okay?

The FACTORY ALARM DISARM WIRE IS
yellow/blue |-| Located in the
drivers kick in a white plug.
Trigger the power unlock and the factory alarm
disarm wires at the same time to disarm the alarm.

Once Located, splice into either wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Now you have both ways
to solve this one.

Have a good day