Questionhow to replace the blower motor fan switch asembly 05 wrangler
AnswerREMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
Disconnect and isolate the battery negative cable.
Remove the center bezel from the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - REMOVAL).
Remove the glove box from the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL).
Reach through the glove box opening and disconnect the two halves of the A/C-heater control vacuum harness connector (A/C-Heater Control - Typical).
Remove the two screws that secure the A/C-heater control to the instrument panel.
Pull the A/C-heater control away from the instrument panel to access the connections on the back of the control.
Disconnect the three wire harness connectors from the back of the A/C-heater control (A/C-Heater Control Connections - Typical) and remove the control from the vehicle.
