Jeep Repair: installing a stabilizer bar repair kit, rubber bushings, jeep cherokee

Question
This job seems very simole but i would like to make sure i am doing it doing it right.How exactly do i install this part on my 94 jeep cherokee 2wd, this bart is for the front of the car

Answer
Hi Jermaine,

If you're replacing the rubber bushings where the stabilizer bar is mounted to the frame then remove the mounting bolts on each side, pull the brackets off of the stabilizer bar, replace the bushings and bolt back on. If you are replacing the link bushings on each end of the stabilizer bar remove then remove the nut on each side, note the position of bushings and washers on the link before you remove them. You'll install the new ones in the same order, replace the nut.

Hope this helps, have a good one.

Kenji