QuestionQUESTION: how do i get to the electrical clip to replace housing unit for the tail lamp?
ANSWER: need to know what kinda jeep U have first of all.
---------- FOLLOW-UP ----------
QUESTION: yeah that would help. Its a 2003 jeep wrangler. 4 cylinder. 2.4 liter. the back right lamp. thank you for your help!
AnswerREMOVAL
Disconnect and isolate the negative battery cable.
From the underside of the vehicle, remove the push-in fastener that secures the bottom rear edge of the rear wheelhouse splash shield to the body.
Pull the rear of the wheelhouse splash shield away from the body and reach upward to disconnect the wire harness connector from the tail lamp.
Remove the screws that secure the tail lamp lens to the tail lamp housing (Tail Lamp Housing).
Remove the tail lamp lens and gasket from the tail lamp housing.
Remove the bolts that secure the tail lamp housing to the body.
Remove the tail lamp housing from the body.
