Land Rover Repair: Thermometer Replace, fog lamps, chassis frame

Question
I am having an issue with my thermometer on my 2000 Range Rover. I am looking on instructions how to replace it with one I purchased. Can you provide any insight?  I'm looking to save a much money as possible since I am in between jobs at the moment.

Answer
from the WS manual:


AMBIENT TEMPERATURE SENSOR - FROM VIN
381431
Service repair no - 82.20.91
Remove
1. Remove front bumper valance. See CHASSIS
AND BODY, Repair.
2. Disconnect multiplug from sensor.
3. Release sensor locating lug from hole in sensor
mounting bracket, rotate and remove sensor.
Refit
4. Fit sensor to mounting bracket, ensuring that
locating lug is fully engaged.
5. Connect multiplug to sensor.
6. Fit front bumper valance. See CHASSIS AND
BODY, Repair.

You can probably reach it without removing the bumper if your flexible....

You can also download the workshop manual free from several locations, google for "land rover rave CD"

FRONT BUMPER VALANCE
Service repair no - 76.22.72
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove battery cover for access to RH fog
lamp.
3. Disconnect fog lamp multiplugs and breather
hoses.
4. Release 2 clips securing bumper ends to
mounting brackets.
CAUTION: Loosen bolts securing bumper
end mounting brackets to chassis frame to
avoid damage to sealing rubber during
bumper remove and refit.

Remove 2 bumper bolt access plugs from
bumper valance. Remove bolts.
6. With assistance remove bumper assembly.
Do not carry out further dismantling if
component is removed for access only.
7. Remove 8 studs and 6 clips securing extensions
spoiler. Remove extension.
8. Remove 8 screws securing fog lamps. Remove
lamps.
9. Remove 8 bolts securing bumper end brackets
to bumper. Remove brackets.
WARNING: If front bumper is damaged due
to impact, the impact cans must be
inspected. There must be no visible
deformation. The overall length must be 188.25
mm æ 0.5 mm. Replace the impact cans if
necessary.
Refit
10. Fit end brackets and secure with bolts. Fit fog
lamps and secure with screws.
11. Fit extension and secure with clips and studs.
12. With assistance fit bumper assembly, tighten
bolts to 70Nm. (52 lbf.ft)
13. Fit bolt access plugs.
14. Align end brackets, tighten bolts and secure
bumper end clips.
15. Connect fog lamp multiplugs and breather
hoses, fit battery cover.
16. Remove safety stands. Lower vehicle.