Mazda Repair: 87 rx7 manual window regulator, latch assembly, guide frame

Question
How do I remove the door regulator?  The Manual shows a clip holding it on but I can't seem to get to it.

Answer
I will assume you are talking about the handle for the window. Using a mechanics pick set, select the one with the most hook to it. Then, press in on the door panel around the window crank and find the loop of the clip. Orientate the window crank to the angle best suited to your comfort and hook the hook into the loop of the clip and pull. Once you have the clip off the window regulator handle should slide right off. To reinstall you simply install the clip onto the handle and then pop it back on the spindle.

If you are referring to the regulator itself as it is installed in the door shell you must unbolt all the 10 mm bolts from the door track and guide frame. Remove the door glass by removing the 10mm bolts at the bottom of the glass and sliding it up and pulling it inwards so it will clear the window frame. Then unbolt the regulators three bolts and slide it upwards and slightly left to unhook it from the inner door shell. It should slide out easily without fussing with the door lock and latch assembly rods.


Regards,

John