Mitsubishi Repair: 92 Mitsubishhi 2.4L Expo, firing order, autozone


Question
My expo was running, I shut it off, tried to start it again, and it just turned over...no start.  Had it all checked out, the computer went on it.  I got a new computer for it, put it in, and while I was at it, put in new wires, plugs etc.  It still won't start.  I checked the firing order, the only confusion was between the #2 & #3. #4 was on top basically, and #1 was on bottom.  So I flip flopped the 2 & 3 once and still no start...HELP!!!  

Answer
James: You need to have your car coded, though the computer was bad. Could be you have bad sensors too. The computer is only as good as it's sensors. If you have an AutoZone close by, they will code your car for free and then you would know what is going on with the sensors. If the sensors and the computer are talking. Hope this helps and good luck!