Motorcycle Repair: 2000 FLHTCI stalling, bank angle, senser

Question
I have read many forums and even this one and have a problem with my Harley stalling. While driving down the highway the bike jerked and then stalled. It would crank but no fire. After about 5 minutes it started again and I could drive a couple miles and same thing. I appears that when the engine gets hot it will stall, the tach goes to zero prior to stall and all other electrical works. Crank it over and it sputters and when I did throw a plug in to check spark, there was spark??? I was thinking the coils broke down with heat or maybe ECM, but with spark? What about the temp sensor? I tested the bank indicator and ok. plugs look ok, maybe a touch lean. No codes that I can see.Where should I go from here? Fuel was about 1/2 tank and i could hear pump. Had the recall to a 50amp main done as well. Thanks for any help.

Answer
If the coils, ECM, and the bank angle senser were bad you wouldnt have a spark at all. I would suppect the temp or the bank angle senser breaking down, but the only way to be sure is to have a dianostic run on the bike and see what the problem is. That way you are not just changing parts until you hit it
Good luck and happy riding
Mike