Questioni have a 95 cbr 600 and i just recently replaced the wiring harness, stator, and rectifier. i got the bike to fire up fine its just now when i try to hit the throttle it will only rev up to about 3500-5000rpm and then die down and almost stall. if i hold the throttle open it revs up and then dies down, revs up and dies down. it keeps doing this as if its pulsating for some odd reason. even if i hold the throttle in one position. its been puzzling me for a couple days. i know my fuel supply is good, and the new stator is kepping the new battery charged without any veriation. im guessing something with my ignition. if u have any ideas for me to check that would be very helpfull. thank u.
AnswerJake,
check the wires coming from the pulser/rotor
area, tighten the connectors, squeeze
the female connector slightly so the
wires make better contact. May be a wire
with a red end on it, if not just tighten
those connections. Poor electrical contacts
usually cause these weird problems.
Double check and clean any main ground
wires, also battery connections.
