Motorcycle Repair: Clutch change, honda cbf, clutch plate

Question
Would need help for changing clutch on Motorbike Honda CBF 400 ( four ) / 1977.
what do i need to know before i start with it,
what do i have to do,
is there a proplem if i never did anything like this before on a motorbike,

the best would be i have picture for step by step to do it.
i would need all information from the moment i open the engine, take the old cluthcplates out and replace for the new ones ( 7 )incl getting all back together.

Answer
Thomas, You will need tools like an impact driver with long phillips head bit, gasket scraper, clutch cover gasket, kickstarter seal, clutch plate kit and springs, wrenches to remove various parts and probably an air wrench to get the special 16mm 4 prong lock nut loosened from the clutch shaft. The clutch hub spins once you remove the springs and lacking a holding tool, an air wrench works best to spin the nut off the shaft... and back on again.

Obviously I can't send a photo through this site. Contact me at my website www.vintagehonda.com and I can scan a page from the repair manual if you wish to proceed.

Bill Silver