Nissan Repair: Battery Empty/Jump/Control is off, nissan sunny 2005, interior illumination

Question
Hi Von,

I have NISSAN Sunny 2005, I forgot the lights on, and the battery is empty, so I jumped the car by using another car. and the car works properly and I could run my NISSAN again.

But unfortunately all my car control became off (Remote not working, when I use the keys not all doors open just one, the back window heater not working, and locking the door from the driver button is off as well)

This problem happened one time ago, and I went to NISSAN Service center and they solve the problem immediately, and they told me the problem was because of the battery, and I did not paid any thing for them.

Now I cannot visit them since the NISSAN Service center is located in another city.

Could you please suggest any solution for this problem.

Regards,
M.Nassif

Answer
Motaz,

You probably have two issues.  First, get the battery fully charged.  Then, inspect the fuses.  Especially those fuses by the battery terminal.  When the battery is low the extra resistance tends to blow fuses.  For the programming of the remote follow these instructions.

The horn chirp can be disable by pressing the lock and unlock buttons simultaneously until the hazard lights flash, and no enable press the lock and unlock until the horn chirp.
To reprogram (enter new ID) key fob (keyless remote controller) follow the steps.
1. Close all doors and lock all doors
2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds.
   (The hazard warning lamp will then flash.)
   NOTE:
   Key should be withdrawn from ignition key cylinder completely each time.
   NOTE:
   Do not rush the insertion/removal key cycling process. The side
   marker/tail/license lamps and interior illumination will flash twice when this step is
   accurately completed.
3.  Insert key on ignition key cylinder and turn ignition key switch to "AAC" position
    At this time, the new ID code is entered and original (previous) ID codes are erase.
4.  Press any button on the new remote controller once. (The hazard warning lamp will then flash)
    NOTE:
    Do not press the button more than one time in the above step. If the button
    is pressed more than one time, the programming procedure will not be successful.
    The side marker/tail/license lamps and interior illumination will flash twice when this
    step is accurately completed and programming is successful.        
               If there is only one remote controller skip  step 5.
                5. Additional  ID code entry
                Release the door lock, then lock again with door lock/unlock switch
                (In power window main switch)
6.  Remove key from ignition
7.  Unlock driver side door, open driver side door and then close the door. (END)
    NOTE:
    If you need to activate more than two additional new remote controllers, repeat
    the procedure on step 5 "Additional ID code entry" for each new remote controller.
    NOTE:
    Entry of maximum four ID codes is allowed and any attempt to enter more will be ignore.

If you need more help email me back.