Oldsmobile/Buick Repair: 95 olds cutlass, 2.2L 4cyl, olds cutlass, slip hook

Question
I have a broken cable guide (tube) that goes from the top of the engine down to the transmission.  The cable is not broken, only the guide tube. It is broken where it attaches to the transmission housing.  I can see some transmission fluid that may have been spashed out.  How difficult is it to replace the cable guide?  How many shops hours should I expect to be charged?  Assuming no other leaks, is the trans fluid I see on top of the cover from a splashing effect w/in the transmission?  Is this a drivable condition to get it to a mechanic?

Answer
hi bob .and yes too all your questions.this repair only takes a half hour so you can expect one hr labor the part will prob high of 4o.oo.yes you can drive it to a mech there is no pressure there.and as far as replaceing it it is simple.unhook the cable from the eng tb.remove bolt holding broken part too trans.pull up on it .now you see a rod attached with a slip hook disconnect it and reverse to install..be sure too replace the o ring also.please take time to rate my service ty billymac