Pontiac Repair: 2001 Pontiac Sunfire window motor replacement, power window regulator, pontiac sunfire

Question
Hello Tim, I am at the point where I have removed the door panel and  water shield.  As I look at the motor it sit behind or inside the actual door. To replace just the motor, do I need to remove the rotor also? If so are you able to give me any directions on the best way to do this? I have bought the repair book, but it does not go into detail about the motor.
thanks kate

Answer
here are some step by step instrutions  hope this helps, I can post or email pictures if needed.  Let me know, Tim



Service Information        
2001 Pontiac Sunfire | Cavalier, Sunfire (VIN J) Service Manual | Body and Accessories | Doors | Repair Instructions | Document ID: 631212
--------------------------------------------------------------------------------

Front Side Door Window Regulator Replacement (Power Regulator)
Removal Procedure
•Lower the window to the three quarters down position.




•Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
•Remove the water deflector in order to access the window regulator. Refer to Front Side Door Water Deflector Replacement .
•Remove the window to regulator nuts (4).
•Push the window to the closed position and tape in place.
•Disconne the regulator electrical connector.
•Removect the power window regulator bolts (3).
•Drill out the power window regulator rivets (2).
•Remove the power window regulator (5) from the door.
Installation Procedure




•Position the power window regulator (5) in the door.
•Connect the door window regulator electrical connector.
•Install the power window regulator rivets (2).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

•Install the power window regulator bolts (3).
Tighten
Tighten the regulator bolts (3) to 10 N·m (89 lb in).

•Remove the tape from the window and push the window down to the regulator.
•Install the power window to regulator nuts (4).
Tighten
Tighten the window to regulator nuts (4) to 10 N·m (89 lb in).

•Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
•Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
© 2010 General Motors.  All rights reserved.