QuestionIN regards to a 3-6-10 reply by Paul in regards to a question regarding an after market coil for a stihl 032av chainsaw he said a Atom Computer Ignition Module would take the place of points in that saw but will it also eliminate the coil. Does that module do both? He says the module "connects between coil primary wire and earth. Is that before the coil,after he coil or without the coil
thankyou
Answer>>Hello Jim:
>>This Ign Module is Designed to Replace the Point Set Only and Not the Coil.
>>I am Not that Familiar with the Atom Ign Module as I Use the Nova ll Ign Module, Rotary # 8786.
>>With the Nova ll the Wire from the Coil to the Point Set is Connected to 1 Side (Marked +) of the Module and the Other Side (Marked -) is Grounded.
>>The Point Set Wires (1 to Coil and 1 to the Kill/Shut Off Switch) are Usually Cut Just Below the Flywheel and the Point Set is Left in Place.
>>Attach the Kill/Shut Off Wire to the Same Lead that goes from the Coil to the Module.
>>I Contacted Atom and the Brown Unit is Suggested because it has a Rev Limiter Built in so the Engine Cannot Over Rev.
>>I was Also Told that the Unit come with Installation Instructions in the Box.
>>If you Hit a Snag or this Does Not Correct the Problem, I Hope to be Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Happy. Thanks.
Good Luck
Respectfully
John
PS: I am Allowed to Answer 5 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.
Respectfully
John
