Small Engines (Lawn Mowers, etc.): adjusting govenor, govenors, carburetor

Question
how do i adjust the govenor on a FH500V Kawasaki eng. ? I ve set the govenors on other eng.s but I,ve never worked on this type eng. before

Answer
Hello Melvin:

>>The Following is an Instruction File I Made for Setting the Governor Arm Correctly. Any Input is Appreciated.  
>>If you Removed/Loosened the Governor Arm from the Governor Shaft or Put the Linkage in  a Bind when the Carburetor was Removed, then Reset the Governor.
>>**To Reset the Governor; Loosen the Governor Arm Bolt and Turn the Governor Shaft Clockwise Until it Stops.
>>Using the Governor Arm Hold the Carburetor to Full Throttle. Now with the Shaft Full Clockwise and the Governor Arm and Carburetor Held at Full Throttle, Tighten the Governor Arm Bolt.
>>If the Engine Still Runs Full Throttle, then Reverse the Rotation of the Governor Shaft, but Still Hold the Carburetor at Full Throttle with the Governor Arm.
>>**If it Still Runs at Full Throttle, then Check the Internal Governor.**
>>You can View a Breakdown/IPL of the Engine at this Site Addy,
http://www.emerichsales.com/ and Select Parts at the Top of the Page. Now Fill Out the Quick Parts Look Up Section.
>>If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Happy. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 5 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.

Respectfully

John