Small Engines (Lawn Mowers, etc.): kohler firing problems, spark plug wire, air gap

Question
im working on two cyl engine i unhooked the kill wire from the electronic ign...cleaned magnets on flywheel and set air gap to 10thousands also i have replaced flywheel key..i purchased a new elec ignition module but a friend stuck it on for me and he touched a 12 volt wire to the kill term on the module..would this destroy it..i performed 3 ohm  tests number 1 between bolts on module and neg battery term and got 0 ohms..test 2 between spark plug wire and bolts on module and got no reading at all...test 3 between kill connector on module with wire unhooked and neg battery term and i got 0 ohm..

Answer
Hello Rick:

>>From your Description it Sounds like the Ign Module is Trashed.
>>Connecting 12 Volts to the Kill (Grounding) Terminal Usually will Destroy the Module.
>>Send me the Make, Model and Type or Spec Numbers Off the Engine, Please. With these I can Locate the Proper Manual and Better Assist you.
>>If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Happy. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.

Respectfully

John