QuestionGrandchild kept starter engaged while the engine was running. I replaced the bad starter and the ignition switch module but still have no spark @ spark plug. When checking for spark, engine will turnover even after hot wire to solenoid is pulled & key turned off! FC420V-ES10.
AnswerHello Terry:
>>Sorry for the Delay. This Question was Located in the Question Pool and I can Only Answer Questions from the Question Pool when I am Not Answering Questions here or at the Other Site I Answer Questions at.
>>If the Battery Voltage is Low and you Engage the Starter, the Starter will Not Disengage and Continue to Turn the Engine or Try to Turn the Engine Until the Battery Voltage is Depleted and Usually the Starter Solenoid is Damaged.
>>To Stop the Starter a Battery Cable has to be Removed from the Battery.
>>Have the Battery Load Tested and Replace if Required.
>>You can View a Breakdown/IPL of the Engine at this Site Addy,
http://www.emerichsales.com/ and Select Parts at the Top of the Page. Now Fill Out the Quick Parts Look Up Section.
>>Please, Do Not Hesitate, If you Hit a Snag, if I Missed Something or this Does Not Correct the Problem, I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.
Good Luck
Respectfully
John
>>PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Comments and Ratings are Greatly Appreciated. Thanks.
Respectfully
John
