Small Engines (Lawn Mowers, etc.): governer seing, dowel pins, crankshaft seal

Question
i replaced the oil pan gasket. put the eng back in. lined up the marks on the governor shaft to were they were before disassembly. when i started it up it ran full throttle. if i manually hold the gov. down it works fine.
john deer lx288 kawasaki eng

Answer
Hello Jason:

Did you Make Sure the Governor Shaft was Correctly Positioned to Make Contact with the Governor when you Assembled the Oil Pan to the Engine.  The Following is a Basic Instruction File for Examining the Inside of a Small Engine and will Assist you in having Access to the Governor, Oil Pump (if Applicable) Cam and Crankshaft Gear. Any Input is Appreciated. **This is a Simple Process. Drain the Oil and Remove the Engine to the Work Bench with the Oil Pan Facing Up. I have a Wooden Rest that was Especially Made to Hold the Engine when in this Position. Using Fine Sand Paper, Remove ALL the Rust and Debris from the Crankshaft. Remove the Oil Pan Bolts. After All the Oil Pan Bolts are Removed; Tap Lightly on the Sides of the Oil Pan to Loosen it from the Dowel Pins. When the Oil Pan is Removed, you can See the Governor Resting on Top of the Cam Gear. ****If Required: Lift Off and Replace with a New Governor. Check the Engine Block for Debris from the Old Governor and Wipe the Inside of the Block With a Rag, Until Clean. Set the Governor Shaft So it will be Resting on the Governor while the Oil Pan is Replaced and Carefully Replace the Oil Pan. If the Crankshaft Seal Was Not Leaking, then Leave it Alone. It Should be OK. You can Easily Replace it While Mounted on the Machine if Required Later. Make Sure the Governor Stays in Contact with the Governor Shaft while Replacing the Oil Pan. Re - Mount the Engine to the Machine. Refill With Oil. Your Internal Governor May Differ.**  The Following is an Instruction File I Made for Making this Adjustment. Any Input is Appreciated.  If you Removed/Loosened the Governor Arm to Remove the Carburetor, then Reset the Governor. **To Reset the Governor; Loosen the Governor Arm Bolt and Turn the Governor Shaft Clockwise Until it Stops. Using the Governor Arm Hold the Carburetor to Full Throttle. Now with the Shaft Full Clockwise and the Governor Arm and Carburetor Held at Full Throttle, Tighten the Governor Arm Bolt. If the Engine Still Runs Full Throttle, then Reverse the Rotation of the Governor Shaft, but Still Hold the Carburetor at Full Throttle with the Governor Arm. If it Still Runs at Full Throttle, then Check the Internal Governor.** If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John