Small Engines (Lawn Mowers, etc.): Sears LT1000 wont run, carburetor body, adjustment screws

Question
I have a Sears LT1000 16HP model # 917.274351, and it is about 4 years old.  Suddenly one day I couldn't get it to start at all, so I purchased a new battery.  Now it starts but only runs for about 5 seconds and shuts off.  This is the first time I have ever had any problem at all with this mower.  What do you think might be wrong?

Answer
Hello Jerry:

1- Usually the Problem you Described is Caused by a Dirty Carburetor.  Remove, Disassemble and Soak the Carburetor Overnight in Carburetor Cleaner (I Use Gunk). I have Found that Most People can Use a Breakdown/IPL and Disassemble the Carburetor Enough for Proper Cleaning. You Only have to Remove the Bowl, Float Pin, Float and Needle Valve and Any Adjustment Screws that Go Into the Carburetor Body. The Welch Plugs Do Not have to be Removed. Then Soak the Carburetor Body and Parts in a 1 Gallon Can of Gunk Carburetor Cleaner Overnight. The Can has a Parts Tray Inside it for the Small Parts. Once the Carburetor and Parts are in the Cleaner, you can Replace the Lid for Safety and to Prevent Accidental Spillage. Then Blow Out the Passages with Compressed Air. Install New Parts if Required. Go to this Site Addy, http://www3.sears.com/ and Enter the Model Numbers in the Upper Left Search Box and Click Go. Then Visually Verify the Equipment and Click Continue. From this Page you can View Diagrams or Parts Lists for you Equipment. 2- The Carburetor Anti-Diesel Solenoid May be Bad. Check the Solenoid. If the Carburetor Shut Off Solenoid has Current, then Remove the Carburetor Solenoid and Go to the Hardware Store. Purchase a Bolt of the Same Diameter and Threads. It Needs to be 3/4" Long. Put this Bolt in Place of the Solenoid. If this Corrects the Engine Problem, then Replace the Solenoid. ***NOTE: THIS IS FOR CHECKING THE SOLENOID ONLY I NEVER SUGGEST YOU OPERATE THE ENGINE WITH THE SOLENOID OUT OF THE CARBURETOR EXCEPT FOR TESTING PURPOSES*** Sometimes the Plunger is Moving, Just Not Far Enough to Allow the Gas to Enter the Jets. You can View a Breakdown/IPL of this Engine at this Site Addy, http://www.smallenginepartswarehouse.com/parts.asp and Select the Shop Online Parts Look Up. Then Select the Model Tab. Then Select the OEM (Briggs and Stratton)and Enter the Model and Type Numbers (283H07-0399). Then Double Click on the Model in the Results Area. Now you can Select the Section of the Engine you Wish to View. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John