Small Engines (Lawn Mowers, etc.): Briggs & Stratton Vanguard Carb, scott bonnar, briggs and stratton

Question
Greeting from Australia.
I have a Briggs and Stratton Vanguard 6hp running a Scott Bonnar Reel Mower. It is running very rich, so much so it does not run in run mode and very rough in full choke mode. My amateur assessment is that i have a Carby problem. I do not however know the location of the carburetor adjustment screw to adjust fuel flow. There are several screws in that area and adjusting them all does not seem to make a difference. Any ideas?

Rob

Answer
Hello Rob:

You can View a Breakdown/IPL of this Engine at this Site Addy, http://www.smallenginepartswarehouse.com/parts.asp and Select the Shop Online Parts Look Up. Then Select the Model Tab. Then Select the OEM and Enter the Model and Type Numbers. Then Double Click on the Model in the Results Area. Now you can Select the Section of the Engine you Wish to View. If you Have Been Turning the Mixture Adjustment Screws and this Did Not Effect the Engine Operation, then the Carburetor Most Likely Requires a Good Cleaning. ****All the Carburetor Adjustments are the Same for Lawn Mower and Trimmers. There are Several Location for the Air Mixture Screws. The Idle Air Mixture Screws are Usually Located at the Top of the Carburetor Bowl or the Top of the Carburetor Body. If the Main Air and Idle Air Mixture Screws are Side by Side on the Side of the Carburetor, then the Idle Air is the Farthest from the Engine. The Main Jet Air Mixture Screw is Located in the Bottom of the Carburetor Bowl or Beside the Idle Air Screw on the Side of the Carburetor Body. Some of the Older Model Carburetors have the Main Jet Mixture Screw Straight in from the Top of the Carburetor Body (this is Rare anymore). If you have Cleaned the Carburetor (Disassembled and Soaked Overnight in Carburetor Cleaner (I Use Gunk). Then Blow Out the Passages with Compressed Air and Install a New Kit if Required. Now Setting the Air Mixture Screws:  ****Turn the Idle Air and ****Main Air Mixture Screws In Until SNUG **Do Not Jam** Then Reverse Both Screws 1 1/2 Turns. Holding the Throttle Full Open, Start the Engine. Turn the Main Air Mixture Screw Clockwise Until Proper Revs are Obtained. Occasionally you May have to Turn this Counter Clockwise to Achieve the Proper Revs. Now Allow the Engine to Idle. Set the Engine Idle Screw (Not Idle Air) so the Engine will Stay Running if Required. Now Set the Idle Air Mixture Screw so there is No Hesitation when Throttling from Idle to Full Throttle. Reset the Engine Idle if Required.**** Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.

Respectfully

John