Small Engines (Lawn Mowers, etc.): wont start :(, adjustment screws, carburetor body

Question
Why?- when I tried to start my lawn mower it first started for like 10 seconds and as soon as i started to go it turned off, then again i pulled the string and again 10 and turned off. But that was the last it did that now it wont even start. I pull and nothing, it has gas, spark plug looks good. That's all i know. thanks in advance

Answer
Hello Viviana:

First, Pour a Small Amount of Fuel Mix Into the Carburetor Throat while Holding the Throttle at Full. Still Holding the Throttle at Full, Try to Start the Engine. If the Engine Starts and Quits, then Remove, Disassemble and Soak the Carburetor Overnight in Carburetor Cleaner (I Use Gunk). I have Found that Most People can Use a Breakdown/IPL and Disassemble the Carburetor Enough for Proper Cleaning. You Only have to Remove the Bowl, Float Pin, Float and Needle Valve and Any Adjustment Screws that Go Into the Carburetor Body. The Welch Plugs Do Not have to be Removed. Then Soak the Carburetor Body and Parts in a 1 Gallon Can of Gunk Carburetor Cleaner Overnight. The Can has a Parts Tray Inside it for the Small Parts. Once the Carburetor and Parts are in the Cleaner, you can Replace the Lid for Safety and to Prevent Accidental Spillage. Then Blow Out the Passages with Compressed Air. Install New Parts if Required. Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.

Respectfully

John