Small Engines (Lawn Mowers, etc.): 2 HP B&S, carburetor body, adjustment screws


Question
The 2HP B&S engine on my edger starts ok, but it will not run unless I leave the choke out at a certain place. If I push the choke in it will die. The edger has been sitting up for 2-3 years.  Can you please help?

Model   60102
Type    0267-06
Code    80102001

Thanks,
Ray

Answer
Hello Ray:

Remove, Disassemble and Soak the Carburetor Overnight in Carburetor Cleaner (I Use Gunk). I have Found that Most People can Use a Breakdown/IPL and Disassemble the Carburetor Enough for Proper Cleaning. You Only have to Remove the Bowl, Float Pin, Float and Needle Valve and Any Adjustment Screws that Go Into the Carburetor Body. The Welch Plugs Do Not have to be Removed. Then Soak the Carburetor Body and Parts in a 1 Gallon Can of Gunk Carburetor Cleaner Overnight. The Can has a Parts Tray Inside it for the Small Parts. Once the Carburetor and Parts are in the Cleaner, you can Replace the Lid for Safety and to Prevent Accidential Spillage. Then Blow Out the Passages with Compressed Air. Install New Parts if Required. You can View a Breakdown/IPL of this Engine at this Site Addy, http://www.smallenginepartswarehouse.com/parts.asp and Select the Shop Online Parts Look Up. Then Select the Model Tab. Then Select the OEM and Enter the Model Numbers. Then Double Click on the Model in the Results Area. Now you can Select the Section of the Engine you Wish to View. Select the Carburetor File. Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting you Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.

Respectfully

John