Small Engines (Lawn Mowers, etc.): Bringgs and Stratton magneto wire, briggs and stratton, copper wire

Question
I am working on an older rear motor snapper with a briggs and stratton 10hp motor.  Through this site and others, I chased down a broken wire to the magneto.  It appears to have been worked on by others (got it two years ago, ran find for a year).  It is the black wire going from the magneto to a post on the front of the engine where the wire from the ignition switch and one from under the starter button cover all bolt on.  The wire is broken at the magneto end.  It is a solid core copper wire.  It is bare on the end suggesting it broke right off the solder right on the magneto.  The problem is, I can't figure out where on the magneto the thing goes.  Is there a place on the internet where I can view pictures of the magneto, or see blown up schematics of it?

Thanks you so much for your time.

Answer
 Hello John:

 If the Wire of which you Speak has Broken Off Even with the Coil, then Replace the Coil.  http://www.outdoordistributors.com/ should have the Diagram you are Looking for. Hope this Helps. Let me know what Happens, Please.

 Good Luck

 Respectfully

 John