Toyota Repair: air bag indicator dash orange light, orange light, sensor assembly

Question
in the last ? about this you said to jump the terminals  for a code where will that code apear and can i just shut the light of ? is there a way to just elimanate the air bags in 1994 camry  to pass inspection the car has never been in acident and all the mecanics i bring it to can not figure out how to shut the light of or find a error code even at the dealer they couldnt figure out the problem and had arguement with a man about trying to charge me and sell me a new car was pretty p o'd about the situation and im going crazy cause of the rejection sticker i have is a real pain the car only has 71,000 origanal miles and i love the car for a simple light on an air bag im gona run in with the law all the time over a sticker please tell me how to get rid of it i am planing on taking the dash apart and removing the l.e.d in the light slot what do you think about it please help much app. thanks again this is the air bag light on the dash the little seat with a man and a little pic of the bag in front of him

Answer
Diagnosis Inspection
AIRBAG WARNING LIGHT CHECK
(a) Turn the ignition switch to ACC or ON and check that the
airbag warning light lights up.
(b) Check that the airbag warning light goes out after approx. 6
seconds.
HINT:
• When the ignition switch is at ACC or ON and the airbag
warning light remains on, the center airbag sensor
assembly has detected a malfunction code.
• If, after approx. 6 seconds have elapsed, the airbag
warning light sometimes lights up or the airbag warning
light lights up even when the ignition switch is OFF, a
short in the airbag warning light circuit can be
considered likely. Proceed to Airbag warning light
system (always lit up) on page AB–81.



DIAGNOSTIC TROUBLE CODE CHECK
1. OUTPUT DIAGNOSTIC TROUBLE CODE
(a) Turn the ignition switch to ACC or ON position and wait
approx. 30 seconds.
(b) Using SST, connect terminals Tc and E
of the DCL2.
SST 09843–18020
NOTICE: Never make a mistake with the terminal connection
position as this will cause a malfunction.
2. READ DIAGNOSTIC TROUBLE CODE
Read the diagnostic trouble code as indicated by the number
of times the airbag warning light blinks.
• Normal code indication
The light will blink 2 times per second.
• Malfunction code indication
In the event of a malfunction, the light will blink. The first number
of the code No. will equal the first digit of a 2–digit diagnostic
trouble code, and after a 1.5 second pause, the 2nd
number of the code No. will equal the 2nd digit. If there are
two or more codes, there will be a 2.5 second pause between
each.
After all the codes have been output, there will be a 4.0 second
pause and they will all be repeated.
HINT:
• In the event of a number of trouble codes, indication will
begin from the smaller numbered code to the larger.
• If a diagnostic trouble code is not output or is
continuously output, proceed to the TC terminal circuit
inspection on page AB–83.


















Give me the trouble codes for the ABS light.
11-15, 22, 31 & 41.