Toyota Repair: Flashing tcc light and contineous abs light after strut and wheel bearing change, output waveforms, wheel bearing

Question
-------------------------
Followup To
Question -
What could I have done that would make these MIL's come on during this repair. The car is a 01 toyota Solaro. The work was done on r/rear of the car. I installed a new abs sensor an that did not fix the problem. I was wondering if you no any thing I could check.
Answer -
I don't know what the tcc light is but the abs light will come on because in most cases when the rear struts are removed it's possible to stretch the abs sensor wires and break them on the inside,you said you replaced one sensor, replace the opposite side rear sensor to fix this. Hello again I would like you to know that I only changed the strut and bearing only on the right side. I have read on other sites that the abs cables could be broken during installing lowering kits,thats why I tried the abs sensor.Do you have any information on pin checking the system from under the hood at the socket. Or maybe another way I can find out what went wrong. Thanks.  

Answer
Is it possible that you have installed a wheel bearing that was non-abs?
Remove the abs sensor and look inside the opening and make sure the abs reluctor wheel(it has a bunch of square teeth) is visible inside the hole for the sensor. Since the MIL came on after the repair it makes sense that whatever you did has something to do with it, the only way I know to check each wheel speed sensor is with the scantool that will display the output waveforms of each sensor.