QuestionQUESTION: My brake light will not go off and it is causing me to fail inspection what should I do to get it to go off?? Also how do you reprogram a new keyless entry? Thanks for your help in advance
ANSWER: For the brake light you will unfortunately have to hunt down the short in the wiring. Easier to let a mechanic do it.
For the keyless entry I need to know the year, make, and model.
---------- FOLLOW-UP ----------
QUESTION: 1996 v6 chevy camaro
AnswerMake sure you have the right keyless entry FOB for your car. Info can be found here: http://autotechs.com/fcc/fccidsearch.htm
Turn ignition switch to OFF position.
Remove RADIO fuse 17 from fuse block.
Cycle ignition switch from OFF to RUN three times within five seconds until the door locks and the hatch release cycle, indicating the Body Control Module is in the Programming Mode.
Press and hold BOTH LOCK and UNLOCK buttons on remote control door lock transmitter for 16 seconds.
Door locks will cycle once, confirming the transmitter code is programmed. The door locks must cycle completely to unlock before proceeding.
Any transmitter code that was previously programmed has been erased.
Body Control Module is now programmed to remote control door lock transmitter.
When programming the Body Control Module to match remote control door lock transmitters, the first transmitter code matched will be stored in memory unless a second remote control door lock transmitter is matched at the same time. If programming the Body Control Module to match a second transmitter, repeat step 4. This must be done before the RADIO fuse 17 is reinstalled.
Ignition switch to OFF.
Reinstall RADIO fuse 17 to fuse block.
