Chevrolet: chevy silverado 1500 brakes, wheel disk brakes, abs brakes

Question
I have a '00 silverado 1500 with 4 wheel disk brakes.  I used a chilton's guide to replace the rear pads.  After changing the pads, the rotors (both) are hanging up and not turning.  I tried trouble shooting, by bleeding both calipers but they still won't turn by hand.  I have abs brakes.  They are not completely locked up, but when i put it in gear and let off the brake it won't move until gas is applied and the whole rotor and assembly get very hot after a short distance.

Answer
Eddie;
Hea. are you shure you got the right size pads?. and did you get the rotors cut.? If they fit right and go in when the pedel is pushed in and release when you let off , than they might just have to wear in a bit, I would go for some short drives and pump the breaks do not keep them down but pump them , they should soon break in but most of the disk brakes do rub just a little and as long as you have them in right and they bleed good than try them out as I said they should wear in, and they do get hot.