GM-GMC: Ignition Cylinder, colum, screw

Question
I have a 1975 Chevy 1/2 ton truck. I tried to replace ignition cylinder. Igot everything off down to the cylinder, where I thought a screw held it in. There was no screw. There seem to be some type of a clip inside the colum at the top, but I still could not get cylinder out. Any help would be greatly appreciated.  Thanks

Answer
Michael ,

Ok There should be set screw or star screw that locks the cylinder . you must also have the key in the cylinder when you remove it . Depending on the manufacture date you might have a pin that you have to push and then pull out your cylinder with the key in it ...PULL OUT

LOOK CLOSE !!!


Let me know !



Dave G