Volvo: 1989 volvo 740gl, e mail address, 1992 volvo 940

Question
The car does have a pick up sensor on the back of the engine. The flywheel has one solid area that is about an inch long.
-------------------------------------------
The text above is a follow-up to ...

-----Question-----
hello I had to replace the engine with a 92 model 4 cyl and the flywheels look different. I installed the flywheel off the 89 engine to the 92. The engine wouldn't start with the flywheel off the 92. The 89 flywheel, the car starts, idles rough, and very weak on power. What is the proper position of the flywheel to be in time?
-----Answer-----
Richie,
If your car does not have a flywheel pick up sensor then the flywheel can go on any way. If it does send me a fax number or e-mail address so I can send a copy of the position.

Answer
Richie,
Ok I have a description of the correct placement along with a photo, however I can not attach it to this page. I can e-mail it or fax it, as long as you get for me an e-mail address or a fax number. Here is the text that I copied and pasted.
ALLDATA Online - 1992 Volvo 940 L4-2320cc 2.3L SOHC Turbo VIN 87 B23OFT - Sc... Page 2 of 3
Installation:
1. Install flywheel (manual transmission) or drive plate (automatic transmission).
2. Turn crankshaft to top dead centre position for cylinder No. 1.
3. Position flywheel/drive plate on crankshaft so that pin A is 15° below horizontal position, see illvstration. NOTE: There are two pins. Do not
choose the wrong one!
4. Install new bolts. Apply sealing compound, P/N 1161 056-5, to bolt threads.
5. Torque to 70 Nm (50 ft Ib). Use gear sector P/N 5112 to lock flywheel.

Automatic Transmission Note position of base plates.
The outer plate must be turned with edge outwards.