Truck Repair: 855STC cummins, torque wrench, cam 350

Question
Now can you give me the same thing on a N-14 Big cam 350.  Thanks
-------------------------

Followup To

Question -
I need the valve setting sequence please!

Answer -
On the STC,you adjust valves & inj on same cyl.The mark A is now 1-6,B is 2-5, & C is 3-4.Valves are Int 0.014 & Exhaust is 0.027.You torque the injector to plunger bottom it out to 90 inlbs.Adjust the Injector first,then the valves.It would be best to run flush through the fuel system BEFORE you adjust injectors because the carbon on the tip of the plunger can stop up the sprayholes.Like get the flush & run it though the engien for an hour the night before your going to adjust the overhead so it can cool off.

Answer
On those you adjust valves & inj on different same cyls.The mark A is now 2-5,B is 3-4, & C is 1-6.Valves are Int 0.011 & Exhaust is 0.023.The injector you set the lash with a special Cummins "T" torque wrench(5-6 inlbs).Adjust the Injector first,then the valves.Like if it was on A#2 you adjust Inj on 4 & valves on 2,turn to B & adjust 1 Inj & 4 valves and continue in firing order.