Car Alarms: toyota 5000, valet mode, dash area

Question
factory fitted 1995. I have tried evrything in the manual eg resync handset, but cannot disable red light by gear stick and alarm triggers each time open door etc. This has been initiated by disconnecting battery (siren disabled). i have disconnected many times in past and after a inicator flash stopped, handset would disarm - i dont know what has changed, but i need an override - any suggestions?
regards martin

Answer
Hmmm, might need to be evaluated by a tech to
trouble shoot the isse. Until then, to try to disarm it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.

That should solve the troubles.

Let me know what you discover.

ALARMTEK
CARALARMMAN.COM