Car Alarms: aps95bt2 prestige security system, valet mode, dash area

Question
hi, i have a 96 blazer with the prestige security system installed. i had the aps95bt2 remote transmitter but it broke. i can unlock the car with the key, but unless the car is not unlocked with the transmitter the starter is disabled. do you know of a way to disable the system, or my best course of action? thanks.

Answer
Right,
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.

ALARMTEK