Car Alarms: Power Locks, power locks, dodge dakota

Question
QUESTION: I have a 2000 Dodge Dakota, and i just installed an alarm. My power locks was not connected because i have a factory installed keyless entry. Because of this my alarm remote wont work, so i installed a three way relay setup so that i could use my alarm remote to unlock my doors. It worked at first, but the next day i pressed the unlock button but only the passenger side door opened, after i used the truck then hit the lock button on the remote, both locks would work. Then the following day non worked, so i disconnected the 3 way relay setup, now the locks wont operate at all. When i hit the door switch, i only hear the relay in the passenger side dash clicking. Whats going on?

ANSWER: You may have toasted the door lock fuses.
I would look to replace that. The alarm you have should also
control the factory system. Go to the wirewerx and get the chart for
this truck. It will show you how to do the keyless entry with
your alarm.

ALARMTEK
WWW.WIREWERX.COM

---------- FOLLOW-UP ----------

QUESTION: How do i find these fuses. I looked in my side panel but my power lock fuse was good, i tested it with another. Where else do i lock for bab relay or fuses. I also looked under the hood but couldnt find a relay or fuse for thhe power lock system. Does it go by another name? What do i do?

Answer
Ah, you need more then a volunteered
answer here.

To start with, get the wiring chart for
installing after market accessories in your
specific vehicle so you can cut out alot of searching.
www.WIREWERX.com

I have Checked My Databases &
This Wire Color/Location/Polarity Data Chart
Is Available To Purchase For Only $4.99.

That will alow you to work safely on this issue.

ALARMTEK