QuestionI have a factory remote. Its just keyless entry with "unlock", "lock", "trunk" and "panic" buttons.
It stopped working and I figured its because of the batteries so I had them replaced today. When I tried to push any buttons, remote did not work excet for the panic. Panic went off and until it stopped by itself (after some time)and when I put the ignition, it beeped not allowing me to start the vehicle. At that timeI pressed the reset button and the beeping stopped and I can start the car.
My remote still does not work. I followed the procedure in your previous answers posted and now I know how to keep the LED always ON or Blinking. But I do not know how to make my remote work to operate my doors and trunk.
Please advice.
Thank you.
AnswerIf you want, try to ID the system & attempt
to order programming instructions
at either of the following locations, try here...
www.AUTOTECHS.com
www.KEYLESSRIDE.com
or, www.REMOTESUNLIMITED.com
All specialize in replacement transmitters and
will most likely have yours as well.
I hope this helps.
ALARMTEK
ALARMTEK.net
