Car Alarms: Lost key that turns alarm on and off, dash area, nissan quest

Question
We lost our remote alarm key and can not start our car becuse the alarm is not disabled. The vehicle is a 1996 Nissan Quest. Is there a way we can disable the alarm so that we can start the car?

Answer
Sorry, watching the Playoffs.
  Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes on solid, and the siren chirps once.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in opposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to usable armed mode.

That should do it.
At This point, you will
want to remove it and put one in that
has a new warranty, and 2 transmitters.

Take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
STARTERDISABLE.com