Car Alarms: How do I reprogram my car..., memory slots, programmable feature

Question
How do I reprogram my car alarm remote the brand micro the led light on the dash dosent light up at all and what are the purpose of the numbers on the remote for a 1994 honda accord ex

Answer
This Is A Code-Learning System, The Alarm Will Learn The Remote Control(s). Therefore Programming New Or
Additional Remote Controls Is A Simple Procedure. There Are Many Settings That Can Be Programmed Into The
System.
ENTERING CODE-LEARNING & PROGRAMMING MODE:
1. Turn The Vehicle's Ignition To The “ON” Position.
2. Press The Valet/Override Button 5 times.
• The Siren Will Emit A Long Chirp & The LED And Parking Lights Will Light Solid To Confirm Entry Into
Code-Learning & Programming Mode.
3. At This Point The Programmer Can Either Code-Learn Remote Control(s) Or Change
Programmable Feature Settings.
NOTE: If At Any Time 7 Seconds Elapse Without Input, The Alarm Will Automatically Exit Code-Learning &
Programming Mode
CODE LEARNING REMOTE CONTROL(S):
Once In Code-Learning & Programming Mode:
1) PRESS THE “LOCK” BUTTON OF EACH REMOTE CONTROL THAT YOU WISH TO
PROGRAM.
**** (OR) ****
• A Maximum Of 4 Remote Controls Can Be Programmed.
• The Siren Will Chirp & Parking Lights Will Flash To Confirm Each Time A Remote Has Been Learned According To
The Number Of The Remote Programmed.
EXAMPLE:
1st Remote Programmed = 1 Siren Chirp & 1 Light Flash
2nd Remote Programmed = 2 Siren Chirps & 2 Light Flashes
3rd Remote Programmed = 3 Siren Chirps & 3 Light Flashes
4th Remote Programmed = 4 Siren Chirps & 4 Light Flashes
2) IT IS ALWAYS ADVISABLE TO FILL ALL FOUR OF THE MEMORY SLOTS:
A) If You Only Have 1 Remote Control Program It 4 Times.
B) If You Have 2 Remote Controls Program Each One Twice.
3) THERE ARE 2 OPTIONS WHEN YOU ARE DONE CODE-LEARNING REMOTE CONTROLS:
A) If The Programmer Does NOT Need To Change Any Feature Settings Then Exit Code-Learning & Programming
Mode By Turning OFF The Vehicle's Ignition. (Turn Off The Key)
B) If The Programmer Needs To Change Programmable Feature Settings Please Refer To The “Programming
Feature Settings” Section Below.
NOTE #1: The Remote Controls Provided With This System Are Already Programmed And Ready For Use. Programming
Is Necessary Only For New Or Replacement Remote Controls.
NOTE #2: Every Time A New Remote Control Is Programmed The Unit's Memory Is Cleared. This Means That Any
Remote Control(s) Previously Programmed In The Memory Have Been Erased And Now HAVE TO BE REPROGRAMED.

The numbers are the FFC identification required for
car alarm manufacturers to be able to sell in this
country. It also helps us get the right remote to the
right system.

Good luck with it.
For further support on this,
contact the people you bought it
from.

Have a good weekend.

ALARMTEK
ExtraSpecials.com